![\"\"](\"https:\/\/www.rebo.nl\/wp-content\/uploads\/2022\/07\/mesdruk-instellingen-blurry.jpg\")
<\/a>\nVinyl, for example, is a relatively thin and flexible material and therefore requires less pressure than a thicker, more rigid material such as aluminium polyester. The extent to which the blade glides through the material also varies depending on the material type. <\/p>\n
Are the labels not being cut deeply enough, or are they being cut too deeply? See below how to resolve this. <\/p>\n
<\/p>\n
As a rule of thumb, the tip of the cutting blade should protrude approximately 0.5 mm. Is your cutting plotter cutting just slightly too deep<\/span> or not quite deep enough<\/span>? In that case, you can leave the blade holder installed in the printer and adjust it by turning the cap to achieve the desired setting. <\/p>\n We generally recommend a blade pressure of approximately 40, up to a maximum of 50. You can check or change this by pressing the black cutting blade icon<\/strong> on the touchscreen. This will open the blade pressure settings screen. <\/p>\n <\/p>\n 1. Press +<\/strong> to increase the blade pressure or –<\/strong> to decrease the blade pressure. <\/p>\n <\/p>\n 2.<\/strong> Then press the blue Test Cut<\/em> icon to perform a test cut.<\/p>\n <\/p>\n 3.<\/strong> Are you satisfied with these settings? Press the green button to confirm. <\/p>\n <\/p>\n The lamination function on your printer allows you to apply a protective layer to your labels. In most cases, the default settings will be sufficient. However, if you notice that your laminated labels are not being cut properly, you can adjust the blade pressure settings for laminated labels separately. <\/p>\n <\/p>\n<\/a><\/p>\n
\nTo adjust this, turn the top cap of the blade holder clockwise to increase the blade protrusion<\/strong>, or counterclockwise to decrease the blade protrusion<\/strong>.<\/p>\n
\nIf you want to make sure that the blade tip protrudes far enough, we recommend removing the entire blade holder from the printer so you can more easily see how far the tip extends. <\/p>\nDefault blade pressure settings.<\/h4>\n
<\/a><\/strong><\/p>\n
\nAdjust the setting gradually until the desired cutting depth is achieved. In most cases, the optimal blade pressure is between 40 and 50. <\/p>\n<\/a><\/strong><\/p>\n<\/a><\/p>\n
\nWould you like to discard the changes? Press the red button to cancel. <\/p>\nBlade pressure for laminated labels.<\/h4>\n
<\/a>
\n1.<\/strong> Press +<\/strong> to increase the blade pressure or –<\/strong> to decrease the blade pressure.
\nAdjust the setting gradually until the desired cutting depth is achieved.<\/p>\n